Table of Contents
Advertisement
Interfaces
mask. It must have the syntax of IPv4_address/netmask.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, set the IP address to an alternate private IP:
(config)> network interface lan ipv4 address IPv4_address/netmask
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the LAN address type
By default, the LAN interface uses a static IP address. To configure it to use a DHCP address instead:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Web UI:
IX10 User Guide
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
134
Advertisement
Table of Contents
