Advertisement
122/301
Bosch Rexroth AG
Programming
7.2.6
Functions under Tools
Tools- Block Numbers
Rexroth IndraMotion MTX 11VRS Standard NC Operation
%V% %TN0003%
%V% %TN0004%
%N% UPTest %TN0005%
%CHEND%
Pasting Advanced Cycle Retrievals
Example:
Advanced call:
//%N% CALL INIT
//%N% Test %P%
//%N% G0 X1111
//%N% G1 X999 F1234
The ID %P% is used as a placeholder for the parameters of the Test subroutine,
which can be assigned in the paste cycles dialog. All the blocks are then trans‐
ferred to the NC program.
Assigning a Graphic to a Parameter
It is possible to assign a graphic to a parameter. The graphic is displayed when
the parameter is activated.
Example:
//%V% REAL %TN2% %GF% G82_R1.jpg %TN8%
The parameter of type REAL with the designation Token TN2 is assigned a
graphic; the graphic shows the content of token TN8 as text.
Use of Text Files
Instead of specifying a concrete text, a language-dependent text can be defined
using token numbers. For this, the corresponding texts have to be defined in a
text file. The text files are also saved to the "User\Config" path of the project.
The file name can be freely selected; it always contains the language ID
"Name_yy.txt" (yy=language ID, e.g.: DE for German). The name of the file to
be used is specified in the header under the keyword %ID%. If only one text file
is used, the name has to be specified in each header.
Creating own Graphics
An "empty" graphics file named "C0.jpg" is located in path "IndraWorks\con‐
fig". This graphics file can be used as a template with the help of a graphics
program (Paint, Photo Editor). It fits the size of the graphic to be used.
Graphics format:
Width: 9.76 cm or 223 pixels
Height: 8.19 cm or 262 pixels.
The template is saved in the same path, but under a new name.
The desired step size (1-10) can be selected for automatic block numbering.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Advertisement
