46/301
Bosch Rexroth AG
General Operation and Visualization
5.2.11
Tool Display
Display Content
Column selection
5.2.12
Tool Correction Display
Display Content
Rexroth IndraMotion MTX 11VRS Standard NC Operation
The Tool display is used to show tools, including the D-correction table path.
Fig.5-16:
Tool display
The columns and variants are selected using the variant editor of the options
dialog . Variants with the following data can be defined:
●
Active tool
●
Tool name active tool
●
Tool type active tool
●
Preselected tool
●
Tool name preselected tool
●
Tool type preselected tool
●
Active edge
●
D number index
●
D length correction L1
●
D length correction L2
●
D length correction L3
●
D radius correction R
●
D edge position
●
Tool length correction L1
●
Tool length correction L2
●
Tool length correction L3
●
Tool radius correction R
●
Tool edge position
●
Tool Euler angle phi
●
Tool Euler angle theta
●
Tool Euler angle psi
The display supports a maximum of 10 variants.
If a date is not available, "—" is displayed.
The tool correction display shows the D-correction, tool name, tool type, exter‐
nal tool values and cumulative correction values.
DOK-MTX***-NC*OP***V11-AP01-EN-P