Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Column selection
5.2.13
Tool Correction Register Display
Display Content
Column selection
Fig.5-17:
Tool correction display
The names of the active and preselected tools are extracted from
the tool database. To display the active tool, it is imperative to set
the active flag in the database from the PLC or the NC.
The columns and variants are selected using the variant editor of the options
dialog . Variants with the following column data can be defined.
●
Length correction L1
●
Length correction L2
●
Length correction L3
●
Radius correction R
●
Euler angle phi
●
Euler angle theta
●
Euler angle psi
●
Edge position
●
Active edge
●
Tool type
The display supports a maximum of 10 variants.
If a date is not available, "—" is displayed.
The tool correction register display shows all the tool correction registers for all
tool edges.
Fig.5-18:
Tool correction register display
The columns and variants are selected using the variant editor of the options
dialog . Variants with the following column data can be defined.
Bosch Rexroth AG
General Operation and Visualization
47/301
Advertisement
