Advertisement
36/301
Bosch Rexroth AG
General Operation and Visualization
Meaning
PLC error status
Network state
Suboperation mode
The suboperation modes of
the machine operation mode
"Automatic"
are shown as symbol and text.
The suboperation modes of
the machine operation mode
"Manual operation (setup)"
are shown as symbol and text.
Symbol Explanation
PLC in stop state
The symbol indicates that there is no symbol table.
The symbol indicates that the PLC program is changed online.
The symbol indicates that a network exists and that all participants operate correctly.
The symbol indicates that a network exists and that at least one participant is not
online or is signaling a warning.
The symbol indicates that a network exists and that at least one participant is sig‐
naling an error.
Continuous block
Single block
Single step
Program block
Leave the contour
Return to contour
Program restart
NC analyzer step mode
NC analyzer continuous mode
Traverse to reference point
Jogging
Jog WCS
There is no suboperation mode in the machine operation mode "MDI". Only the
symbol is shown.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Advertisement
