Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Sorting Tool List
Filter active (F7)
The following settings dialog can be used to configure and activate list sorting
according to 3 decreasingly prioritized sorting criteria. For multiline sorting col‐
umns within one sublist, the corresponding subline can be entered for which it
should be sorted. At the same time, this dialog can also be used to restore the
original, "unsorted" list display.
Fig.8-21:
Settings dialog for sorting the tool list
In the example, the tool list is sorted first according to the T-number, then ac‐
cording to the sector number and then according to the location number, each
in ascending order.
Empty locations are shown at the end of the list here.
If the "Original sequence" checkbox is activated, sorting is switched off.
The function can be opened via the following menu function in the default con‐
figuration Edit ▶ Sorting the tool list .
Dynamic updating of the sorting order is executed in the list display
after value modification. To accomplish this, the sorting dialog has
to be retrieved again.
The list display can be filtered according to the condition defined in the setting
dialog.
A filtered list is indicated in the list title by "(*)".
The function can be also opened via the following menu function in the default
configuration Edit ▶ Filter active .
The function is only active if a filter condition has previously been
activated.
Bosch Rexroth AG
177/301
Tool Management
Advertisement
