Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
10.6
MTX System Status
10.6.1
Introduction
The MTX system status is a commissioning application and diagnostic appli‐
cation for PC-based MTX controls.
This application controls, monitors and visualizes the state of the following
component groups:
●
MTX standard
●
MTX performance
●
MTX advanced
The MTX system status is embedded in the diagnostic display and can be
opened via <F5>after calling the diagnostic display with <OP9>.
After calling the application, it is displayed as shown below.
Fig.10-36:
MTX system status
The MTX system status is divided into 3 sections.
In the upper section "Properties", you can find general information on:
●
Name:
The name configured for the respective control in the IndraWorks Engi‐
neering is displayed.
Bosch Rexroth AG
213/301
Diagnostics
Advertisement
