Advertisement
108/301
Bosch Rexroth AG
Operation Modes
Rexroth IndraMotion MTX 11VRS Standard NC Operation
"Chain view" Window
Fig.6-39:
"Chain view "
This window displays the selected dimensional chain of tool and workpiece.
This window cannot be focused. In case of setting changes in other windows,
it is refreshed.
"Settings" window
Fig.6-40:
Settings
In this window, the different variants for the tool measurement can be set. The
settings in this window are shown as far as possible in the "Chain view" window.
The tool correction value to be measured is selected by the selection of axis
and plane.
During tool measurement with active ZO, "All, Selection and None" are distin‐
guished. At "Selection", another window is displayed used to select from which
zero point databases the active zero point offsets should be considered for
calculation.
Optionally, the active D-correction can be selected for calculation.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Advertisement
