Advertisement
278/301
Bosch Rexroth AG
Extended Functionality
Error display
Troubleshooting
11.6.5
Circumferential Calculations
Overview
Layout
●
Nominal size outside the range from 1 to 500 mm and
●
You have tried to determine a non-preference tolerance.
With all error causes, a uniform error message appears in the lower part of the
form. The focus is automatically reset to the entry field.
Using the <Esc> key, you can reject the latest entry or edit the entry field.
Tasks
The circumferential calculation is most often used for programming radial pro‐
cessing types if programming takes place in a coordinate system to be trans‐
formed - here the unwinding - and the positions on the circumference are
available as angles. With a given reference diameter (unwinding diameter), you
can fulfill the following tasks:
●
Conversion of an angular pitch into a circumferential coordinate and
●
Conversion of a circumferential coordinate into an angular pitch.
The form for circumferential calculations is located on the tab labeled with
"Circumference".
The form provides editable text boxes for the numerical values. Behind the text
boxes that are in the fore and can be considered for a value transfer, buttons
for copying purposes are located.
Fig.11-31:
Form for circumference calculations
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Advertisement
