Advertisement
286/301
Bosch Rexroth AG
Extended Functionality
Calculating cutting velocity
Feed Calculations
Calculating the Feed
Calculating fees velocity
Errors
Error Causes
Error display
Rexroth IndraMotion MTX 11VRS Standard NC Operation
2.
Enter the diameter and the cutting velocity in the provided fields. In this
connection, expressions are allowed (see
order of the entry is of no importance.
3.
Initiate the calculation using the return key or by changing the focus.
4.
If conversion into the other metric system is necessary, activate "Metric
system Inch".
The cutting velocity can be calculated in the following way:
1.
Ensure that the metric system suitable for your entries is active. For the
Anglo-American metric system, "Metric system Inch" must be checked.
2.
Enter the diameter and the speed in the provided fields. In this connection,
expressions are allowed. The order of the entry is of no importance.
3.
Initiate the calculation using the return key or by changing the focus.
4.
If conversion into the other metric system is necessary, activate "Metric
system Inch".
The feed can be calculated in the following way:
1.
Ensure that the metric system suitable for your entries is active. For the
Anglo-American metric system, "Metric system Inch" must be checked.
2.
Enter the speed. If the speed is not known, it is to be calculated from the
cutting velocity. Refer to
3.
Enter the number of teeth 1 if you want to get the feed per rotation; oth‐
erwise, enter the number of teeth of the tool.
4.
Enter the feed speed.
5.
Initiate the calculation using the return key or by changing the focus.
6.
If conversion into the other metric system is necessary, activate "Metric
system Inch".
The feed speed can be calculated as follows:
1.
Ensure that the metric system suitable for your entries is active. For the
Anglo-American metric system, "Metric system Inch" must be checked.
2.
Enter the speed. If the speed is not known, it is to be calculated from the
cutting velocity. Refer to
3.
Enter the number of teeth 1 if you know the feed per rotation; otherwise,
enter the number of teeth of the tool.
4.
Enter the feed.
5.
Initiate the calculation using the return key or by changing the focus.
6.
If conversion into the other metric system is necessary, activate "Metric
system Inch".
Errors are caused in the entry of values and/or expressions. The following cau‐
ses can be considered:
●
Inadmissible mathematical operations,
●
Syntax errors and
●
exceedance of a value range.
In the lower part of the form, an error message appears, either with reference
to the violated value range or as format error. The focus is automatically reset
to the faulty entry field.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Syntax for
Calculating the Cutting
Velocity/Speed.
Calculating the Cutting
Velocity/Speed.
Expressions). The
Advertisement
