Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
F-keypad
Control "Zero Axis Selection Reference Position"
Fig.6-23:
Control "Zero Axis Selection Reference Position"
The decisive display control of the "Zero Reference Position" screen is the
control "Zero Axis Selection Reference Position". It is used to display and select
the axes to be zeroed and for the command call for zeroing. It is focused by
default.
Fig.6-24:
F-keypad of the control "Zero Axis Selection Reference Position"
●
<All Axes>
It selects/deselects all axes
●
<Next Axis>
It focuses the selection of the next axis
●
<Select>
It selects/deselects the focused axis
●
<Zeroing>
It calls the command for zeroing
●
<Next Window>
It focuses the next display control
●
<Options...>
It opens the "Options" dialog of the control
●
<Stop Zeroing>
It closes the active screen
"Options" Dialog "Properties - Zero Axis Selection Reference Position"
Fig.6-25:
"Options" dialog of the control "Zero Axis Selection Reference Posi‐
tion"
The "Options" dialog of the control "Zero Axis Selection Reference Position"
contains the two tabs "View" and "Axis Filter".
Additionally, it includes the following buttons:
OK
It exits the dialog and the set properties are applied.
Bosch Rexroth AG
97/301
Operation Modes
Advertisement
