Advertisement
244/301
Bosch Rexroth AG
Extended Functionality
Error message number and message
text number
Messages regarding problems when loading information from the configuration file
(#88)
It is not possible to set one or more
breakpoints after loading a configuration
file.
The breakpoints are deleted from the list
of breakpoints.
(#90)
When loading a configuration file, it is not
possible to set active breakpoints be‐
cause the Dry Run mode is not set.
(#20)
The number of variables cannot be de‐
termined.
(IVariable::GetNumberOfVariable)
(#22)
The current variable value cannot be de‐
termined.
(IVariable::GetVarValue)
(#28) The current NC state cannot be de‐
termined. (INcsChannel::GetNcState)
Cause
No active NC program when loading in‐
formation from the configuration file.
NC-Analyzer mode was not set.
The configuration file was written while
working with another flow program.
The NC program was changed after the
configuration file has been saved.
DryRunMode was not set.
Messages regarding connection problems with the NC
Timeout too short.
Timeout too short.
Timeout too short.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Recommended to the user
Loading information from the configura‐
tion file only after selection of a flow pro‐
gram.
Set the NC-Analyzer mode.
(DryRunMode should also be set). Load‐
ing information from the configuration
file.
Continue (information on breakpoints
from this configuration file is lost).
If information on breakpoints just written
in the configuration file - used to start the
application - has to be saved, save the
configuration file under a different name
to still use it without closing the applica‐
tion.
It is recommended to compile the config‐
uration files for specified NC programs
and to start the programs only with their
individual configuration files.
(The flow program name can for example
be used as the configuration file name:
TEST.CPL test.cld).
This message does not appear if this rec‐
ommendation is followed.
Continue (information on breakpoints
from this configuration file is lost).
Set DryRunMode and click on the Gen‐
eral Inhibit button.
(NC Analyzer Mode should also be set).
Loading information from the configura‐
tion file.
Close and restart the application.
Close and restart the application.
Close and restart the application.
Advertisement
