Advertisement
214/301
Bosch Rexroth AG
Diagnostics
10.6.2
Status Information
10.6.3
Restarting NC
Rexroth IndraMotion MTX 11VRS Standard NC Operation
●
IP address:
The IP address and the onboard Ethernet address entered in the network
configuration are displayed.
The middle section displays the following:
●
Status information:
The status information of the control is displayed via red and green LEDs
(see
chapter 10.6.2 "Status Information" on page
●
NC:
In this section, the NC information is displayed (see
starting NC" on page
●
PLC:
In this section, the PLC information is displayed (see
"Starting/Stopping the PLC" on page
The lower section is split in two:
●
The results of the last control restart executed with this application are
displayed on the left (see
●
The device information is displayed on the right.
The status information of the control is displayed using red and green LEDs:
●
TCP/IP
green LED = Data exchange is active
green LED (not filled) = No data exchange between interface and control
●
Fieldbus
green LED = Fieldbus function ok
red LED = Problem with fieldbus
●
Backup battery
green LED = Correct buffer battery state
red LED = Buffer battery discharged or buffer battery not available
The NC display in the middle section is provided with the following:
●
NC status field:
This field visualized the current NC status which is displayed in color and
short form. The used abbreviations are described in
"Startup Configuration" on page
startup.
●
Info field with detailed status description:
The abbreviations in the status field are explained in this field.
Use <F2> to execute an NC restart. The F-key opens the following dialog. In
this dialog, the startup mode
216
can be specified for a restart.
DOK-MTX***-NC*OP***V11-AP01-EN-P
214).
215).
chapter 10.6.5 "Saving Details" on page
216. This field is flashing during control
chapter 10.6.7 "Startup Configuration" on page
214).
chapter 10.6.3 "Re‐
chapter 10.6.4
215).
chapter 10.6.7
Advertisement
