Advertisement
56/301
Bosch Rexroth AG
General Operation and Visualization
Context-dependent Functions of the MTX Navigators
Context program
Context program selection
Context Engineering
5.4.2
Operation
General
Rexroth IndraMotion MTX 11VRS Standard NC Operation
●
the number of the objects (directories and files) and
●
the sum of the sizes of all files
which are directly below the selected directory are shown.
The status bar in the IndraWorks Operation is - as shown in
Navigator in the characteristic "Tree+List" of the IndraWorks Operation" on
page 55
- located directly below the navigator. In the IndraWorks Engineering,
the general status bar of the IndraWorks Engineering is used.
In the IndraWorks Engineering the status display is deleted auto‐
matically after 10 seconds.
The MTX Navigator is used in the IndraWorks Operation in two different oper‐
ating ranges:
●
In the operating range "Program"
●
In the operating range "Machine"
Additionally, the navigator is also used in the IndraWorks Engineering.
According to the context, the navigator provides different functions.
The instance of this context is always activated as soon as the operating range
"Program" is called in the IndraWorks Operation. In this case, the navigator is
the basic application for this operating range.
In this context, the navigator provides all functions for the file editing.
The characteristic of the navigator is always "Tree+List" and cannot be switch‐
ed.
The instance of this context is called and started with the operation mode
"Automatic" via the "F2 Program Selection" function in the operating range
"Machine" of IndraWorks Operation. This function is not possible in other op‐
eration modes.
In this context, the MTX Navigator provides apart from the general functions
(see
chapter "General Functions" on page
gram selection.
By default, the MTX Navigator is started in this context with the characteristic
"List". However, the user can switch between both characteristics "Tree+List"
and "List".
The instance of this context is called in the IndraWorks Engineering via the node
"NC File System" below the node "Movement".
In this context, the navigator provides all functions for the file editing.
The characteristic of the navigator is always "Tree+List" and cannot be switch‐
ed.
This section describes the different operating possibilities of the MTX Navigator.
The operation in different contexts proceeds on the assumption of different en‐
tering media. The interface is partially operated by mouse (operating ranges
"Program" and in the IndraWorks Engineering) and partially by the keyboard
(operating range "Machine"). However, an operation with the keyboard is al‐
ways possible. However, in certain areas, the operation with the mouse is
easier.
DOK-MTX***-NC*OP***V11-AP01-EN-P
fig. 5-32 " MTX
58), the functionalities for the pro‐
Advertisement
