Advertisement
146/301
Bosch Rexroth AG
Programming
<F5 Save As
<F6 Print
<F8 Exit all Editors
<F5 Copy
<F6 Paste
<F5 BoF>
<F6 EoF>
<F7 Previous value>
<F8 Next value>
7.5.3
Zero Point Offsets
General Information on Zero Offsets
Rexroth IndraMotion MTX 11VRS Standard NC Operation
The current table can be saved under a different name. In doing so, the table
editor remains open.
The print dialog for printing the current table is opened.
<Exit all editors> is used to exit all open table editors of the corresponding data
type (D corrections, zero offsets or placements).
Edit
The contents of the selected cell are copied into the clipboard.
The contents of the clipboard are pasted into the selected cell. The selected
cell enters the editing mode; this prevents the pasted value from being imme‐
diately transferred to the NC. Pressing the <Return> key adopts the value and
transfers it to the NC. Pasting can be cancelled with <Esc> if the cell is in editing
mode.
Navigate
The cursor jumps to the beginning of the table (line 1, column 1).
The cursor jumps to the end of the table (last line).
The cursor jumps to the cell to the left of the selected cell. If the cursor is at the
beginning of a line, it jumps to the last column of the previous line.
The cursor jumps to the cell to the right of the selected cell. If the cursor is at
the end of a line, it jumps to the first column of the next line.
Tools
This is used to open an F-keypad containing additional functions of the corre‐
sponding table editor.
The zero point editor is used for visualization and to enter the zero point values
of individual axes. A comment with a maximum of 32 characters can be as‐
signed to each correction value. If the offset applies to a specific channel only,
this is displayed in an additional headline.
DOK-MTX***-NC*OP***V11-AP01-EN-P
Advertisement
