Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
10.6.4
Starting/Stopping the PLC
10.6.5
Saving Details
10.6.6
Firmware Information
Fig.10-37:
MTX NC restart
If the checkbox "Show all modes" is not selected, the user can only chose be‐
tween 3 modes.
0
Normal mode (default)
6
Bootstrapping and
7
Recreating the user FEPROM file system.
The PLC display in the middle section is provided with the following:
●
PLC status field:
This field visualizes the current PLC status displayed in color and short
form.
–
"RUN" is displayed on green background during normal mode in the
display.
–
If the PLC is at rest, "STOP" is displayed on red background.
–
If no PLC program is loaded, a "?" is displayed on grey background.
●
Info field with detailed status description:
The abbreviations in the status field are explained in this field. The fol‐
lowing detailed descriptions exist:
–
RUN = PLC is running
–
STOP = PLC is at rest
–
"?" = No program
If the PLC is running, use <F3> to stop the PLC (and vice versa).
The results of the last control restart executed with this application are visual‐
ized in the lower section on the left.. Date, time, phase and their meanings are
displayed. The display is refreshed after each restart.
If required, this information can be saved in a "*.log" file with <F4>. The path
under which the file is to be saved is arbitrary. The application saves this infor‐
mation under the default name "Details.log".
A window with the following data can be opened with <F5>:
Bosch Rexroth AG
215/301
Diagnostics
Advertisement
