Advertisement
216/301
Bosch Rexroth AG
Diagnostics
Software version of the MTX kernel
Software version of the subsystems
Windows software components
10.6.7
Startup Configuration
Startup
Rexroth IndraMotion MTX 11VRS Standard NC Operation
●
Software version of the MTX kernel
●
Software version of the subsystems
●
Version information on the Windows software components
Fig.10-38:
Information on the Firmware
Returns information on the general software version of the MTX kernel as well
as a copyright message (version of the basic software and the customer up‐
grades).
Provides information on software versions of the subsystems in the MTX kernel.
The following data is provided for each subsystem:
●
Subsystem name
●
Release number
●
Time stamps
Provides version information on the Windows software components which (un‐
der Windows) provide the communication interface for the MTX kernel. included
is:
●
the NCS interface (ncstyp3.dll),
●
the text management (tsvtyp3.dll),
●
the logical device MTX
(SCPBricDevice.dll, SCPBricComponent.dll) and
●
FIS (FisServer.dll).
The following data is provided for each component:
●
Subsystem name
●
Release number
●
Time stamps
MTX starts while switching on the control or while triggering an NC restart. The
startup occurs synchronized in 12 phases displayed in the MTX system status:
P: -3
Determining the existing hardware
P: -2
RTOS startup, configure file systems
P: -1
Start RTOS monitor
P: 1
Initialize basic NCS communication
P: 2
Initialize TCP/IP
DOK-MTX***-NC*OP***V11-AP01-EN-P
Advertisement
