Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Preference Tolerances
Finding an Allowance
Entering nominal size and toler‐
ance field
Transferring the Allowance
Error
Error causes
Fig.11-30:
Form for using the tolerance dimension table
The following tolerance fields are listed for shafts:
a11, c11, d9, e8, f7, f8, g6, h5, h6, h9, h11, j6, k6, n5, m6, n6, r5, r6, s6, s8, u8,
x8, and x11.
The following tolerance fields are listed for holes:
A11, C11, D10, E9, F7, F8, G6, G7, H6, H7, H8, H11, J6, J7, K7, M6, M7, N6,
N7, P6, R7, S7, X9, and X11
Enter the nominal size followed by the tolerance field. In this connection, spaces
are admissible. Expressions are not allowed.
Example:
Allowances for a hole: 60 H6
Allowances for a shaft: 22.5 f8
Using the return key or by changing the focus, the determination of the allow‐
ance is initiated.
Select one of the three listed allowances and press "Copy".
The following causes in the entry can be considered:
●
Invalid specification,
Bosch Rexroth AG
277/301
Extended Functionality
Advertisement
