Advertisement
96/301
Bosch Rexroth AG
Operation Modes
6.3.3
Functions in Manual Mode
Setting Reference Position to Zero
F-keypad
Rexroth IndraMotion MTX 11VRS Standard NC Operation
"Zero Reference Position" Screen
Fig.6-21:
"Zero Reference Position" Screen
The "Zero Reference Position" screen is used to set the reference position to
zero with the displays of the current axis positions, zero point offsets and tool
corrections. The screen can be opened in the operation mode "Jog" via M-keys
Suboperation mode\Zero reference position.
Fig.6-22:
F-keypad of the "Zero Reference Position" screen
It focuses the display control "Zero Axis Selection Reference
●
<Axis Selection>
Position"
●
<Stop Zeroing>
It closes the active screen
The asynchronous subroutine (Asup) 8 is currently reserved to re‐
alize the setting up functions such as "Zero reference position". To
avoid program conflicts, the Asup 8 may not be used for individual
NC programs by the user.
In
the
"NCO/FileOrg/SrchPathSubProg" (search path for subroutines),
the search paths "usrfep" and "usr/bosch" must be entered since
the NC program was stored there to set up functions or since the
NC program is program-internally written for "Zero reference posi‐
tion".
DOK-MTX***-NC*OP***V11-AP01-EN-P
MACODA
parameter
3080
00001
Advertisement
