Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Navigate
Cancel
Functions on the "Navigate" level
Next Word
Previous Word
Return
Returning to Contour with Block Pre-run
Overview
Application
●
Close subroutine
●
Find - Opening a dialog to enter a search term
●
Navigate - Opening the subsequent level
●
Apply block
●
End position of target block
●
Cancel block pre-run or block search
Find
A dialog to enter a character string to be searched in the complete program
opens. It can be selected between upper case or lower case as well as the
direction of the search. Replacement is not possible.
A subsequent level is opened where more functions are grouped.
The function "Block search" or "Block search" is cancelled.
The "Navigate" level provides the following functions:
●
BoF
●
EoF
●
Next word
●
Previous word
●
Return
BoF
The long cursor jumps to the beginning of the file.
EoF
The long cursor jumps to the end of the file.
The cursor jumps to the next word. If the line is exited, the long cursor also
jumps to the new line.
The cursor jumps to the previous word. If the line is exited, the long cursor also
jumps to the new line.
Return to main level.
Returning to contour with block pre-run after program abort provides the option
of continuing the processing of the NC program with as little effort as possible,
as far as it has reached or exceeded a defined and programmed NC block
(returning to contour block). A returning to contour block is defined by pro‐
gramming the NC function "ReentContBlk()", (short form "RCB()" ) in the NC
program.
If an NC program is aborted during processing, processing should begin at a
predefined position immediately. Reasons for an abort can be tool rupture,
power failure, NC control error, etc. For these cases, the NC programmer can
determine where (NC block) returning to contour in the NC program is reason‐
able. This block is marked with "RCB(1)" in the NC program. If the NC program
is aborted after this block, returning to contour with block search is possible.
Returning to contour with block search after a program abort is only
possible in operation mode "Continuous Block".
The function "Returning to contour with block pre-run" can be projected to a
free F- or M-key. The function to be projected is "Re-entry".
The default M-key assignment is the "Re-entry" key in the "Program functions"
level.
Bosch Rexroth AG
79/301
Operation Modes
Advertisement
