Advertisement
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
Bitmap Display
F-keypad
<F2>
<F3>
level
1. Level
Functions in the Tool Editor
<F7 Next window>
<F3 Next Control>
<F5 Change type on / off (F5)
<F5 Save Tool Basic Data>
Fig.8-39:
Bitmap and memory location display
It is not possible to enter values in this data container.
<F4>
<F5>
Save basic
data
Fig.8-40:
function keys of the tool editor (bitmap display)
Since the tool editor consists of several data containers, navigation to edit these
data is possible only within the data container having the focus. This function
allows the focus to be switched to the next data container.
If the highlighted data container contains several controls, this function can be
used to move the next display control to the foreground.
This function is available only for editing an already existing tool. It can be used
to specifically switch type modification on and off.
When the tool type is changed, all user data are deleted (all data
under DBT1/Rec/UD).
Fig.8-41:
Caution - data will be deleted
This function is available only if a basic data control is activated.
It permits influencing a tool basic data set belonging to the current tool type by
adopting the data set of the current tool as the new basic data set in the tool
catalog.
The following message is intended to explain the effects of the function on con‐
tinued work with the tool catalog to the user.
Bosch Rexroth AG
<F6>
<F7>
<F8>
Next
window
187/301
Tool Management
<F9>
Editor
editor
Advertisement
