DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
6.2.6
Applying NC Blocks from the MDI-Editor to an NC Program
6.3
Manual Mode
6.3.1
Suboperation Modes
6.3.2
Jogging Options
Fig.6-20:
NC block display
To apply NC blocks from the MDI-Editor to an NC program or to apply parts of
an NC program to the MDI-Editor, an NC program has to be opened using the
NC-Editor in the "Program" mode, as has to be an NC screen in the "Ma‐
chine" mode using the MDI-Editor. The NC blocks are exchanged by highlight‐
ing the desired blocks, saving them to the clipboard (<Ctrl>+<C>) and inserting
them to the desired location in the MDI-Editor with <Ctrl>+<V>.
In the standard, the following suboperation modes can be selected via M-keys:
●
"Homing"
●
"Jogging"
●
"Jogging in coordinates"
The following jogging options can be set in the standard via M-keys:
●
Continuous jogging
●
Jogging 1:
●
Jogging 0.1:
●
Jogging 0.01:
●
Jogging 0.001:
Bosch Rexroth AG
95/301
Operation Modes