Warnings and Errors
Load model material
•
Indicates that model material has not been loaded into the printer.
•
Correct condition - load model material. See
Load support material
•
Indicates that support material has not been loaded into the printer.
•
Correct condition - load support material. See
Replace invalid model spool
•
Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
not compatible with the associated head type.
•
Correct condition - disconnect the invalid material coil box and replace it with a valid
material coil box. See
To Printer" (page 98)
Replace invalid support spool
•
Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
not compatible with the associated head type.
•
Correct condition - disconnect the invalid material coil box and replace it with a valid
material coil box. See
To Printer" (page 98)
Replace empty model spool
•
Indicates that the material coil box has run out of material.
•
Correct condition - disconnect the empty material coil box and replace with a new material
coil box. See
Printer" (page 98)
Replace empty support spool
•
Indicates that the material coil box has run out of material.
•
Correct condition - remove the empty material coil box and replace with a new material coil
box. See
(page 98)
Load/Unload Errors
Timed out
•
Indicates that filament was not detected at the head within 5 minutes of a load's initiation.
•
Correct condition - disconnect the material coil box and ensure that it is properly prepared
for installation and load. See
Material Coil Box To Printer" (page 98)
"Loading Material" (page
Purge failed
•
Indicates that filament is currently in the head, but the load failed.
"Unloading Material" (page 105)
for instructions.
"Unloading Material" (page 105)
for instructions.
"Unloading Material" (page 105)
for instructions.
"Unloading Material" (page 105)
for instructions.
"Material Coil Box Preparation" (page 97)
97)).
© Copyright 2020 Stratasys. All rights reserved.
"Loading Material" (page 97)
"Loading Material" (page 97)
and
"Connecting Material Coil Box
and
"Connecting Material Coil Box
and
"Connecting Material Coil Box To
and
"Connecting Material Coil Box To Printer"
for details. reconnect the material coil box (see
Load/Unload Errors
for instructions.
for instructions.
and
"Connecting
Page 196