Operating & Maintaining the Connex500/350 3D Printer
Calibrating the
Load Cells
6–56
After examining the UV calibration results:
1. Click
.
Next
2. Remove the UV sensor and close the printer cover. After confirming
the items listed in the wizard screen, click
Figure 6-85: Final UV Calibration Wizard screen
Load cells are sensors that measure the weight of the material cartridges
and the waste container in the printer. It is important that you periodically
check that the weight measurements are accurate, both for convenience and
to prevent unnecessary waste of printing materials. It is recommended that
you calibrate the load cells once a month.
To calibrate load cells:
1. Start the Load Cell Calibration wizard from the Options menu (see
figure 6‐27 on page 25).
2. Select one or more load cells that you want to calibrate, and click
Figure 6-86: Load cell selection
.
Next
DOC-13025 Rev. A
.
Next