Table of Contents
Advertisement
Stratasys J826 User Guide
Calibrating the Load Cells
Load cells are sensors that measure the weight of the material cartridges and
the waste container in the printer. It is important that you periodically check that
the weight measurements are accurate to prevent unnecessary waste of
printing materials or printer malfunctions.
To calibrate load cells:
1. Start the Load Cell Calibration wizard from the Options menu.
2. In the following screen, select one or more load cells that you want to
3. Remove each selected cartridge from the materials cart, and click Next.
4. In the next wizard screen, observe the numbers and wait until the weight
DOC-28000 Rev. I
Figure 4-121 Final UV Calibration Wizard screen
calibrate.
Figure 4-122 Load cell selection
level is relatively stable—two units above or below the average level
shown.
4 Operating and Maintaining the Printer
4-85
Advertisement
Table of Contents
