Table of Contents
Advertisement
CHANGING TIPS WITHIN THE TOP COVER
Any time the printer's material type is changed, tips must also be changed. If you are following the steps
outlined within
"Using the Tip Change
step 11
on
page 140
and proceed with the wizard.
Warning: Always use an approved ladder or step stool when working with
components under the top cover.
Gloves: Liquefier tips can be hot. You must wear safety gloves (provided in the
Welcome Kit) when replacing tips.
1.
Open the top cover.
2.
Place the head in the head maintenance bracket. Refer to
page 36
for instructions.
Figure 5-18:
Wizard", complete the steps below to change tips, and then return to
Head in Maintenance Bracket
"Head Maintenance Bracket" on
161
Advertisement
Table of Contents
