Table of Contents
Advertisement
Customer Replaceable Units
Installing the Louver Panels
1. Engage the slotted mounting bracket of the louver panel with the rear cover standoff
fastener.
2. Align the louver panel mounting holes (2) with the holes in the cover buttress.
3. Use a 3 mm hex wrench to reinstall the mounting screws (2) that secure the louver panel to
the cover buttress. Torque to 21 in-lbs. See
4. Use a 3 mm hex wrench to reinstall the louver panel mounting screws (3) that secure the
louver panel to the cover support bracket. See
5. Install the right side panel. See
6. Install the rear panel. See Installing the Rear Panel on page 5-7.
Top Cover Assembly
Required Tools
•
3mm hex wrench
•
5 mm hex wrench
Removing the Top Cover
1. Power off the printer. See
2. Remove the rear panel. See
3. Remove the right and left side panels. See
4. Remove the right and left side louver panels. See
(page
5. Using a 5 mm hex wrench, remove the screws (2) that secure the back cover to the top of
the printer frame.
6. Open the oven door to release the top cover latch.
7. Open the front top cover.
8. Using a 3 mm hex wrench, remove the screws (4) that secure the cover assembly
buttresses to the left and right side support brackets. See
9. While holding the front cover open, gently disengage the cover buttresses from the
retaining pins on the left and right side support brackets. See
"Powering OFF the Printer" (page
165).
© Copyright 2020 Stratasys. All rights reserved.
Figure 20 (page
Figure 20 (page
"Installing the Side Panels" (page
"Removing the Rear Panel" (page 161)
"Removing the Side Panels" (page
"Removing the Louver Panels"
Top Cover Assembly
165).
165). Torque to 30 in-lbs.
164).
159).
162).
Figure 21 (page
167).
Figure 21 (page
167).
Page 166
Advertisement
Table of Contents
