Rear Top Cover - Stratasys F170 User Manual

REAR TOP COVER

Required Tools
2.5 mm hex wrench
•
Removing the Rear Top Cover
1. Power OFF the printer. See
2. Open the oven door to release the top cover latch.
3. Open the front top cover.
4. Using a 2.5 mm hex wrench, remove the screws (2) that secure the rear top cover to the cross
bar.
5. Slide the rear top cover back and remove it from the printer. See
Figure 7-15:
Installing the Rear Top Cover
1. Align the rear top cover with its mounting holes (2) in the cross bar.
2. Using a 2.5 mm hex wrench, install the screws (2) that secure the rear top cover to the cross bar.
See Figure 7-15.
3. Close the front top cover.
4. Close the oven door.
"Powering Off" on page
Rear top cover removal
169.
Figure
174
7-15.