Front Top Cover - Stratasys F170 User Manual

FRONT TOP COVER

Required Tools
2 mm hex wrench
•
Removing the Front Top Cover
1. Power OFF the printer. See
2. Open the oven door to release the front top cover latch.
3. Open the front top cover.
4. Using a 2 mm hex wrench, remove the hinge mounting screws (4) from the crossbar.
See Figure 7-14.
Figure 7-14:
5. Lift the front top cover up and away from printer to remove.
Installing the Front Top Cover
1. Align the front top cover hinges with the mounting locations on the crossbar. See
2. Using a 2mm hex wrench, reinstall the hinge mounting screws (4). See
3. Close the front top cover.
"Powering Off" on page
Front Top Cover Hinge Mounting Screw Locations
169.
173
Figure 7-14.
Figure 7-14.