Formatting An Access Controller On The Neteco; Setting Monitoring Parameters For The Newabel Chd200G Fingerprint Controller - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)

6.5.3.3 Formatting an Access Controller on the NetEco

This section describes how to format access control cards, historical records,
timezones, and holidays.
Prerequisites
You have the operation rights for Access Control Management.
Context
The door access controller synchronized by the ECC800-Pro to the NetEco does not
support formatting.
Procedure
Step 1 Log in to the NetEco client.
Step 2 Choose Maintenance Management > Security Protection > Access Control
Management from the main menu.
Step 3 In the Device Management tab page, click
confirm dialog box is displayed.
Step 4 Click Yes. The access controller is successfully formatted.
----End
6.5.3.4 Setting Monitoring Parameters for the NEWABEL CHD200G
Fingerprint Controller
Context
This section applies to the settings of the card reader with a keypad, fingerprint
and card reader, and fingerprint and card reader with a keypad.
Procedure
Step 1 Set the baud rate of the NEWABEL CHD200G fingerprint controller to 9600 on the
ECC800-Pro collector. The preset address is 1. The address does not need to be set.
When creating the device on the NetEco, set Device Address to 1.
----End
Issue 02 (2021-05-12)
NO TE
● After formatting the access controller, click
the timezones are enabled. The access controller is not disabled even if the parameters
are not initialized or the timezones are not enabled.
● Synchronize the timezones and then the user groups or holidays after an access
controller is formatted and parameters are initialized.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
in the Operation column. The
to initialize parameters. In this manner,
261