Installing An In-Room Single-Door Magnetic Lock - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
2.
Figure 3-66 Installing a magnet
(1) Rubber pad
Step 7 (Optional) Adjust the magnet.
1.
2.
----End

3.9.3 Installing an In-Room Single-Door Magnetic Lock

Issue 02 (2021-05-12)
Figure 3-65 Installing positioning pins of a magnet
Insert the assembled magnet into the positioning holes in the door, and
secure the magnet to the door using the screws and rubber pad delivered
with the electronic lock, as shown in
NO TE
When securing the magnet to the door panel, do not over-tighten the screws so that the
rubber pad is elastic. The rubber pad will adjust the magnet to a correct position because of
its elasticity.
If the magnet cannot attract the door properly after power-on, place a
magnetized metal part near the magnet to check whether the magnet
provides a proper magnetic force.
If the magnetic lock and the magnet do not work properly, check and
troubleshoot the circuit.
Copyright © Huawei Technologies Co., Ltd.
Figure 3-66.
3 Installing Devices
57