Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 238

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 2 Configure the PC IP address and the WAN1 IP address in the same network
segment.
If the WAN1 port IP address is 192.168.8.10, subnet mask is 255.255.255.0, and
default gateway is 192.168.8.1, set the PC IP address to 192.168.8.12, subnet mask
to 255.255.255.0, and default gateway to 192.168.8.1.
Step 3 Set LAN parameters.
1.
2.
3.
4.
5.
Step 4 Set Internet Explorer parameters.
1.
2.
3.
Issue 02 (2021-05-12)
NO TE
● If the ECC800-Pro connects to a LAN and a proxy server has been selected, perform
3.3 and Step 3.4.
● If the ECC800-Pro connects to the Internet, and the PC in a LAN accesses the Internet
over a proxy server, do not perform
access the ECC800-Pro.
Open the Internet Explorer and choose Tools > Internet Options.
Click the Advanced tab and select Use TLS1.1 and Use TLS1.2.
(Optional) Click the Connections tab and select LAN settings.
(Optional) On Proxy server, clear Use a proxy server for your LAN.
Click OK.
When you use Internet Explorer for access, set Internet Explorer to ensure the
normal display of and operations on the WebUI. Choose Tools >
Compatibility View, and add the web access address to the compatibility
view.
Choose Tools > Internet options > Security, choose Add the ECC800-Pro IP
address to the list of trusted sites.
Figure 6-59 Adding an address
Enable file download and set the security level of the trusted site to low.
Copyright © Huawei Technologies Co., Ltd.
Step 3.3 and Step 3.4. Otherwise, you will fail to
6 Adding Devices
Step
227