Installing A Temperature And Humidity Sensor (Bom Number: 02312Pbl) - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 2 Install the ambient temperature and humidity sensor to the position specified on
the wall, and secure it using bolts.
Step 3 Reinstall the front cover for the temperature and humidity sensor.
Figure 3-25 Installing the temperature and humidity sensor
----End
3.7.6 Installing a Temperature and Humidity Sensor (BOM
Number: 02312PBL)
Prerequisites
A temperature and humidity sensor (BOM number: 02312PBL) and tools for
installing it have been prepared.
Context
●
●
Preparations
Tool: Phillips screwdriver
Materials: temperature and humidity sensor, temperature and humidity sensor
base
Document: temperature and humidity sensor installation position diagram
Procedure
Step 1 Install the T/H sensor base at the right column position of the IT cabinet about 1.6
m high above the floor in the aisle, and then clamp the T/H sensor onto the base.
Step 2 Set device addresses for the T/H sensors.
Set the device address for a T/H sensor by operating the DIP switch on the sensor.
Toggle switches 1–6 are used to set the device address, toggle switch 7 is reserved,
and toggle switch 8 is used to switch the temperature display mode. The device
Issue 02 (2021-05-12)
For details about how to install an ambient temperature and humidity sensor
and connect its cables, see shipped documents.
Connect cables to an ambient temperature and humidity sensor before
installation.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
35