Replacing An Ivs1800 - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
●
Procedure
Step 1 Loosen the four ST39 tapping screws on the camera.
Figure 7-17 Removing the M2121 camera
Step 2 Disconnect the monitoring network cable and remove the camera from the wall.
Step 3 Install a new camera, reconnect the network cable, and secure the camera to the
base using screws.
Step 4 Adjust the camera coverage based on video images.
----End
Follow-up Procedure
Check whether the new camera works properly. If video images are properly
displayed on the video screen of the management system client, the new camera
works properly.

7.2.5.2 Replacing an IVS1800

Prerequisites
●
●
●
Context
Videos cannot be recorded during the replacement of the IVS1800.
Issue 02 (2021-05-12)
A spare camera of the same model is available and functional.
NO TE
The methods for replacing the M2121 and IPC6225 cameras are similar. This section uses
the M2121 camera as an example.
Recommended tool: Phillips screwdriver
An IVS1800 needs to be replaced.
A spare IVS1800 of the same model is available and functional.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
301