Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 176

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Parameter
Connection Mode
Authentication
Password
Timeout Period
Step 8 Click
Step 9 Click Connection test to start the connection test.
----End
Issue 02 (2021-05-12)
Description
Connection mode of a device. You can set this parameter to
Non-SSL Connection or SSL Connection.
If you modify the connection mode on the NetEco, you
must modify the connection mode on the device WebUI
accordingly.
NOTE
● Connection Mode for the NetEco and device must be the same.
● By default, Connection Mode is set to SSL Connection for the
NetEco and device.
● A non-SSL connection has security risks. You are advised to
select the secure SSL connection.
NOTE
Battery detectors accessed through the UPS do not support device
software management.
Re-authentication password for the NetEco and device.
1. Click Modify.
NOTE
After the device is saved, the Modify button is displayed.
2. In the displayed dialog box, enter the New Password
and Confirm Password.
NOTE
– The default re-authentication password for the NetEco and
device is Modifyme_123.
– The device password should be consistent with the NetEco
password.
– If the password does not meet requirements, modify it on
the device.
3. Select a value for Send To Device.
NOTE
If you select YES, the re-authentication password for the NetEco
and device is changed at the same time. If you select NO, only
the re-authentication password of NetEco is changed on the
server.
4. Click OK.
Timeout duration for a connection test. The default value is
3s.
on the toolbar to save the device information.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
165