Connecting The Ups Monitoring Cable; Connecting The Ups2000-G/Ups2000-H Monitoring Cable (Snmp) - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN
switch.
----End

4.2.5 Connecting the UPS Monitoring Cable

4.2.5.1 Connecting the UPS2000-G/UPS2000-H Monitoring Cable (SNMP)

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of a network cable to the Ethernet port on the SNMP card of the
UPS2000-G/UPS2000-H.
Figure 4-11 Ethernet port
(1) Ethernet port
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN
switch.
----End
Issue 02 (2021-05-12)
Figure 4-10 Main control module
(1) COM/FE port
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
84