Replacing A Location-Type Water Sensor And Water Detection Cable - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Figure 7-15 Connecting a conversion cable to a water sensor
Step 2 Replace a water detection cable.
1.
2.
Figure 7-16 Connecting a new water detection cable
(1) Conversion cable end B, connecting to the
water detection cable
----End
Follow-up Procedure
Check whether the new water sensor works properly. Connect the network cable
between the water detector and the ECC800-Pro, immerse the water detection
cable in water, and check whether an alarm is generated. If an alarm is generated,
the replacement is complete.

7.2.4.6 Replacing a Location-type Water Sensor and Water Detection Cable

Prerequisites
●
●
Issue 02 (2021-05-12)
Remove the faulty water detection cable from the port.
Install a new water detection cable, as shown in
NO TE
The water detection cable and conversion cable are interconnected through the male and
female connectors.
The water sensor needs to be replaced.
A spare water sensor of the same model is available and functional.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
Figure 7-16.
(2) Water detection cable end A, connecting to
the conversion cable
299