Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 118

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
●
Figure 4-28 General cable connections for the access control system
● Connect the RS485 ports on the access controller and the fingerprint and card reader (with a
keypad) respectively to any two of COM1 to COM4 ports on the ECC800-Pro collector.
● Fingerprint and card reader (with a keypad) refers to the fingerprint and card reader with a
keypad or the fingerprint and card reader.
Connecting Cables to the Exit Button
Figure 4-29
using the cord end terminal to crimp the cable.
Figure 4-29 Connecting cables to the exit button
Issue 02 (2021-05-12)
The following figure uses the double-door access controller as an example to
illustrate the wiring method for the access control system. In this example, the
fingerprint and card reader (with a keypad) connects to the CH1 terminal on
the left of the access controller, the card reader with a keypad connects to the
CH2 terminal on the left of the access controller, the double-door magnetic
lock connects to the CH1 terminal on the right of the access controller, and
the single-door magnetic lock connects to the CH2 terminal on the right of
the access controller.
NO TE
shows the cable connections to the access controller and exit button,
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
107