iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Connecting Cables to the Fingerprint and Card Reader with a Keypad
The following figure shows the cable connections to the access controller and
fingerprint and card reader with a keypad, using the cord end terminal to crimp
the cable.
Figure 4-30 Connecting cables to the fingerprint and card reader with a keypad
●
●
Issue 02 (2021-05-12)
Connect one end of the network cable to the female connector of the
fingerprint and card reader with a keypad. Strip the other end of the network
cable and connect it to the access controller terminal, as shown in the
preceding figure.
NO TE
If the network is non-standard, connect it by referring to the cable sequence in the
following table.
Table 4-31 Cable connections for the fingerprint and card reader with a
keypad
Conversion Cable
Red wire
Green wire
White wire
Black wire
Connect one end of another network cable to the RS485 port on the
fingerprint and card reader with a keypad, and connect the other end of the
network cable to the non-energized COM port on the ECC800-Pro collector.
The following table shows the pin mapping for the RS485 port and the COM
port.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Wire of the Network
Cable
Pin3
Pin4
Pin5
Pin8
Access Controller
Terminal
R-12V
R-D0
R-D1
R-GND
108