Setting The Ecc800-Pro System Type - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Figure 6-62 Changing the ECC800-Pro IP address
Step 3 Click Submit.
----End

6.5.1.3 Setting the ECC800-Pro System Type

Prerequisites
●
●
●
●
●
Context
When connecting the ECC800-Pro outside the smart module to the NetEco, you
need to set the system type to General.
Procedure
Step 1 Log in to the ECC800-Pro WebUI as an administrator.
Step 2 Choose System > System Parameters > Site Configuration, set System type to
General, and click Submit.
Issue 02 (2021-05-12)
You have obtained the IP address (192.168.8.10 by default) of the ECC800-Pro.
The browser (Internet Explorer 11 or later, Firefox, or Chrome) for logging in
to the ECC800-Pro WebUI is available.
You have installed hardware for the ECC800-Pro and powered it on.
A PC with an IP address in the same network segment as that of the ECC800-
Pro is connected to the ECC800-Pro over a LAN switch.
You have obtained the IP address, subnet mask, and default gateway planned
for the ECC800-Pro.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
230