Installing A Smoke Detector - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)

3.7.4 Installing a Smoke Detector

Context
●
●
●
●
Procedure
Step 1 Take out the smoke detector base and mark mounting holes for the base in the
appropriate position.
Figure 3-23 Mounting holes (unit: mm)
Step 2 Drill holes and install expansion tubes. Install the smoke detector base to the top
of the room.
Issue 02 (2021-05-12)
The smoke detector is used to detect the smoke density indoors. When the
smoke density exceeds the alarm threshold, the detector generates alarms.
The smoke detector is applicable to the space with an area less than 20
square meters and a height less than 6 m.
The smoke detector is installed on the top of the room within the area to be
detected.
Prior to installing the smoke detector, properly connect the detector cables to
avoid unnecessary rework.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
33