Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 271

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
1.
2.
3.
4.
5.
Step 7 Go back to the planning configuration page of the access controller. Click
Connection test. If the connection is successful, the A8802RS access controller is
connected to the NetEco.
----End
Follow-up Procedure
After an access controller is created, its information is displayed on the Device
Management page, as shown in
Figure 6-80 Checking the access controller information
After the access controller is added, format it manually in the access controller list
to avoid failure in initializing the access controller.
Issue 02 (2021-05-12)
On the main menu, choose Device Management > Configuration > Device
Integration.
In the navigation tree on the left, choose Transparent Transmission Channel
Management.
Select the IP address of the ECC800-Pro connected to the access controller
and click Modify.
In the dialog box that is displayed, set Connection mode to Security
protocol. Set Password to the authentication password that you have set on
the ECC800-Pro, enter the confirm password, and click OK.
Click OK.
Figure 6-79 Transmission Channel Management
NO TICE
Copyright © Huawei Technologies Co., Ltd.
Figure 6-80.
6 Adding Devices
260