Installing A Card Reader With A Keypad - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 3 Install the baseplate, as shown by (3) in
Step 4 Route the fingerprint and card reader cable through the cable hole in the
baseplate, as shown by (4) in
The fingerprint and card reader is connected to the access actuator by a network cable.
Step 5 Check that cables are correctly connected.
Step 6 Secure the fingerprint and card reader to the baseplate, as shown by (5) and (6)
in Figure
Figure 3-76 Installing a fingerprint and card reader
----End

3.9.6 Installing a Card Reader with a Keypad

Context
●
●
Procedure
Step 1 Remove the screws (set aside) from the card reader with a keypad and remove the
baseplate, as shown by (1) in
Step 2 Mark the mounting holes using a marker, and drill holes using a hammer drill.
Issue 02 (2021-05-12)
NO TE
3-76.
It is recommended that the product be installed 30–300 mm close to the
equipment room door and 1.4–1.6 m above the floor.
Do not install the product in a place with heavy dust or exposed to sunlight.
Copyright © Huawei Technologies Co., Ltd.
Figure 3-76.
Figure 3-76.
Figure 3-78.
3 Installing Devices
63