Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 122

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Pay attention to the polarity when connecting cables.
Figure 4-34 Connecting cables to the access controller
(1) Connecting the power cable for the access
controller
Table 4-33 Power cable connection for the access controller
Power Supply
Power supply outside the equipment
room
Related Information
Table 4-34 Card reader and key terminal definition
Terminal Identity
BT
R-AL
R-BP
Issue 02 (2021-05-12)
NO TE
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
(2) Connecting to the power supply, as
described in Table 4-33
Cable Connection
Install the connector (BOM number:
14170096) to the other end of the
power cable and connect the power
cable to a circuit breaker in the power
supply outside the equipment room.
Definition
Key input
Card reader pry signal input
Control card reader buzzer
111