iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
detector placed near the collector by the conversion cable.
components.
Figure 7-14 Water sensor components
(1) Water sensor
(4) Conversion cable end B,
connecting to the water
detection cable
Recommended tool and material: crimping tool
Procedure
Step 1 Replace the water sensor.
1.
2.
3.
Issue 02 (2021-05-12)
Remove the conversion cable at the conversion port for the water sensor and
conversion cable.
Connect a new water sensor to the conversion cable, as shown in
Secure the new water sensor.
Copyright © Huawei Technologies Co., Ltd.
(2) Conversion cable end A,
connecting to the water detector
(5) Water detection cable end A,
connecting to the conversion cable
7 Device Maintenance
Figure 7-14
shows the
(3) Conversion cable
(6) Water detection cable
Figure
7-15.
298