Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 182

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
3.
Issue 02 (2021-05-12)
Table 6-6 IP address parameters
Parameter Description
IPv4 address Method for obtaining the IP address. The options are
assignment Obtain IP address automatically and Use the
following IP address. The default value is Obtain IP
address automatically.
IPv4 address Camera IP address. This parameter is available only
when IPv4 address assignment is set to Use the
following IP address.
Enter the planned IP address, for example,
192.168.1.161. IP addresses starting with 127 are
invalid. You must enter an IP address starting with a
value that ranges from 1 to 223.
IPv4 gateway Gateway IP address of the network where the camera is
located. The default value is 192.168.0.1.
IPv4 subnet Subnet mask of the network where the camera is
mask located. The default value is 255.255.255.0.
Primary DNS Primary DNS IP address. The default value is 0.0.0.0.
Secondary DNS Secondary DNS IP address. The default value is 0.0.0.0.
On the View tab page, click the General tab to access the General tab page.
Select Video and set the parameters, as shown in the following figures.
Figure 6-22 Setting primary stream parameters
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
171