Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 77

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
3.
Step 2 Mark the mounting holes using a marker and the base.
Figure 3-80 Marking mounting holes (unit: mm)
Step 3 Drill holes using a hammer drill, and route cables out of the cable hole.
Step 4 Install the emergency door release button.
Figure 3-81 Installing an emergency door release button
1.
2.
3.
----End
Issue 02 (2021-05-12)
Remove screws from the base, and remove the base, as shown by (4) in
Figure 3-79.
Install the base of the emergency door release button, as shown by (1) in
Figure 3-81.
Install the glass panel of the emergency door release button, as shown by (2)
and (3) in Figure 3-81.
Tighten screws of the emergency door release button using a Phillips
screwdriver, as shown by (4) in
Copyright © Huawei Technologies Co., Ltd.
Figure 3-81.
3 Installing Devices
66