Table of Contents
Advertisement
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Figure 4-36 Wiring diagram for sensors
4.3.6.2 Connecting the Temperature Sensor Monitoring Cable
Prerequisites
The RS485 monitoring cable is prepared.
Procedure
Step 1 Connect the temperature sensor to the temperature and humidity sensor.
1.
2.
Step 2 Connect the temperature and humidity sensor to the UIM20A expansion module.
Issue 02 (2021-05-12)
Connect one end of the network cable to the wiring port on the temperature
sensor.
Connect the other end of the network cable to the NTC1~3 or NTC4~6 port
on the temperature and humidity sensor.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
116
- Quick Links:
- Installing a Lan Switch
Hide quick links:
Advertisement
Table of Contents
