Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 201

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Table 6-9 Modbus TCP parameter settings
Parameter
Link mode
Client
encryption
Server
encryption
Encryption
operation
CBC
NMS IP
address
NMS port
number
Pre-shared
password
Step 4 Return to the home screen, and choose Settings > Comm Settings > WAN IP
Settings or Settings > Comm Settings > IP Settings.
Table 6-10 Parameters for WAN IP settings
Parameter
IP address
Issue 02 (2021-05-12)
Setting Setting Method
Server, ● If you set Link mode to Server, the smart
Client, Server
and client
● If you set Link mode to Client, the smart
● If you set Link mode to Server and client, the
Enable, This parameter is configurable when Link mode is
Disable set to Client.
Enable, This parameter is configurable when Link mode is
Disable set to Server.
Enable, Encryption operation CBC is enabled by default.
Disable Determine whether to use the encryption
operation CBC when connecting to other devices
based on the site requirements.
- Enter the actual IP address of the NMS. IP
addresses of the display panel, NMS client, and
NMS server must be unique. This parameter is
configurable when Link mode is set to Client.
- This parameter is configurable when Link mode
involves Client.
● Connecting to the NetEco: Set this parameter to
● Connecting to other NMSs: You are advised not
- Secondary authentication password used for
Modbus-TCP connection.
Copyright © Huawei Technologies Co., Ltd.
cooling product, as a server, supports two client
connection and establishes communication.
cooling product, as a client, can connect to a
remote server and establish communication.
smart cooling product, as a server, supports two
client connection and establishes
communication. In addition, the smart cooling
product, as a client, can connect to a remote
server and establish communication.
32907 if Client encryption is enabled, or set it
to 32906 if Client encryption is disabled.
to change the value. In special cases, set this
parameter based on the site requirements.
Setting
Set according to the actual plan.
6 Adding Devices
190