Connecting Cables To Sensors - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 2 Prepare an RJ45 connector on one end of the network cable by following to the
instruction in
Step 3 Connect the green core wire 6 and the brown-white core wire 7 to the cables
routed out from the door status sensor.
Step 4 Connect one end of the RJ45 network cable to the AI/DI port on the ECC800-Pro
collector.
----End

4.3.6 Connecting Cables to Sensors

4.3.6.1 Connecting Cables to Sensors
If the ECC800-Pro collector is connected to the following types of sensors, connect
cables to the devices by referring to
Issue 02 (2021-05-12)
4.3.1 Preparing a Monitoring
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Cable.
Figure 4-36.
115